Adhesive sticks to most rough surfaces such as brick, wood, concrete and more and requires time for adhesive to set before mating the hook and loop so you have time to reposition. Adhesive is also water-resistant. Extreme tape is designed for permanently placing items.
Adhesive sticks to most rough surfaces such as brick, wood, concrete and more and requires time for adhesive to set before mating the hook and loop so you have time to reposition. Adhesive is also water-resistant. Extreme tape is designed for permanently placing items.
Peel tape from fastener and press firmly into place
Adhesive reaches maximum strength after 24 hours
Note: Recommended for temperatures between 0°F to 140°F. Not recommended for fabrics, dashboards, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener. May not adhere well to certain types of brick - testing is recommended.
Removal Instructions:
Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
Stick the ball on the adhesive which is on your substrate and pull it off
Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners
