Extra strong hook and loop fasteners, Holds up to 10 lbs. Water resistant adhesive. Ideal for indoor or outdoor use. Sticks to most surfaces, including plastic. Excellent alternative to drilling, nails, screws, or epoxy.

More from the Manufacturer

• Plastic
• Multi Surface
• Industrial

• Water Resistant
• Heavy Duty

• Indoor / outdoor use
• Superior adhesive for most surfaces
• 50% stronger than standard hook and loop fasteners

Strips

Care and Application:

Instructions:

• Clean and dry surface before application
• Peel tape from fastener and press firmly into place
• Adhesive reaches maximum strength after 24 hours

Note: Recommended for temperatures between 0°F to 120°F. Not recommended for fabrics, dashboards, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener.

Removal Instructions:

• Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
• Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
• Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
• Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
• Stick the ball on the adhesive which is on your substrate and pull it off
• Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
• If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners

Weight Rating:

1 lbs per square inch up to 10 lbs

Functional Temperature Range:

0-120° F (-18-49° C)