VELCRO Brand Sticky Back hook and loop fasteners deliver strong holding power. Simple peel and stick application. For smooth surfaces such as painted wallboard, glass, metal and most plastics, can be used for indoor or outdoor applications. VELCRO Brand is the original hook and loop fastener. Much better durability and strength than other off brand fasteners. They are available in squares, coins, strips, and tapes and come in a range of different sizes and colors. A must have for any home, school or office. Great for organization, mounting, hanging, and securing. Instructions: 1. Clean and dry surface before application. 2. Peel tape from fastener and press firmly into place. 3. Adhesive reaches maximum strength after 24 hours. Note: Not recommended for fabrics, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener.
VELCRO Brand Sticky Back hook and loop fasteners deliver strong holding power. Simple peel and stick application. For smooth surfaces such as painted wallboard, glass, metal and most plastics, can be used for indoor or outdoor applications. VELCRO Brand is the original hook and loop fastener. Much better durability and strength than other off brand fasteners. They are available in squares, coins, strips, and tapes and come in a range of different sizes and colors. A must have for any home, school or office. Great for organization, mounting, hanging, and securing. Instructions: 1. Clean and dry surface before application. 2. Peel tape from fastener and press firmly into place. 3. Adhesive reaches maximum strength after 24 hours. Note: Not recommended for fabrics, flexible vinyl or underwater use. Continued exposure to full sunlight can damage fastener.
Peel tape from fastener and press firmly into place.
Adhesive reaches maximum strength after 24 hours.
Note: Not recommended for fabrics, flexible vinyl or outdoor use. Continued exposure to full sunlight can damage fastener.
Removal Instructions:
Warm the tape (Hook or Loop) with a hair dryer. (Do not use a heat gun)
Peel off the tape (Hook or Loop) the adhesive will remain on the substrate
Warm the adhesive with the hair dryer (again, do not use a heat gun), peel off a piece and roll in a ball
Cool the adhesive down. This may be done with ice in a plastic bag (only takes a few moments)
Stick the ball on the adhesive which is on your substrate and pull it off
Repeat step # 5 until the adhesive is completely removed from the substrate. This may take some time
If any residue tackiness remains on the substrate you may now use a commercial remover like Goo Gone, acetone, WD-40, mineral spirits or citrus based cleaners
