Crew Non-Acidic Restrooms Floor and Surface Disinfectant effectively cleans, disinfects and deodorizes in one easy step. Disinfectant kills HIV-1, Staphylococcus aureus, Salmonella choleraesuis, E. coli, MRSA, VRE and other microorganisms. Use to clean hard, nonporous and washable surfaces - inside and outside of the restroom. Non-acidic disinfectant cleaner leaves behind a refreshing fresh scent. No rising is required on non-food contact surfaces.
Crew Non-Acidic Restrooms Floor and Surface Disinfectant effectively cleans, disinfects and deodorizes in one easy step. Disinfectant kills HIV-1, Staphylococcus aureus, Salmonella choleraesuis, E. coli, MRSA, VRE and other microorganisms. Use to clean hard, nonporous and washable surfaces - inside and outside of the restroom. Non-acidic disinfectant cleaner leaves behind a refreshing fresh scent. No rising is required on non-food contact surfaces.
For use on hard, nonporous inanimate environmental surfaces such as floors, walls, glazed porcelain, glazed ceramic tile, plastic surfaces, shower stalls, bathtubs and cabinets.
To disinfect inanimate, hard nonporous surfaces, dilute according to label directions.
Apply solution with a mop, cloth, sponge or hand-pump trigger sprayer so as to wet all surfaces thoroughly.
Allow to remain wet for 10 minutes then remove excess liquid.
For heavily soiled areas, a pre-cleaning step is required. Prepare a fresh solution for each use.
For J-Fill® Use:
Insert cartridge into dispenser (see J-FILL® dispenser instructions for proper cartridge placement). Fill small bottle or bucket or use gun to apply a foam directly onto surfaces to be cleaned, scrubbing with a soft brush, pad or cloth. Do not allow foam to dry. Rinse surfaces thoroughly. NOTE: Some commercial strength cleaners are unsuitable for use on some surfaces. Test in an inconspicuous area prior to use.
For RTD® Use:
Fill trigger spray bottle with product. Apply to surfaces to be cleaned.
Wipe with clean cloth or towel to dry. Dilute with cold water.
To avoid food contamination after cleaning, sanitize and rinse all food contact surfaces with potable water before reuse.
For Command CenterTM/MC Use:
Command CenterTM/MC: Attach bottle to Command CenterTM/MC Dispensing System and fill ready to use chemical by actuating touch point (reference Command Center dispenser instructions). Connect hose to cold water tap.
Safety Warning
Please make sure your employees read and understand the product label and Safety Data Sheet before using this product. The label contains directions for use; and both the label and SDS contain hazard warnings, precautionary statements and first aid procedures. SDS are available online at www.diversey.com or by calling 888.352.2249. Improper use or dilution may result in damage to surfaces and may result in health and physical hazards that match those of the concentrate.
